Common knowledge of foam cutting machine

　　Extend the service life of consumables:

　　1. Ensure that the voltage is the standard voltage: too high or too low input voltage will cause the heating change of the resistance wire and shorten the service life of the hot wire.

　　2. the cutting pattern is within the permitted range: the foam cutting machine can not be cut under the condition of exceeding the working thickness.

　　3. The resistance wire cannot be used for a long time: the cut resistance wire melts the template by the heat generated. If it is used for a long time, the temperature of the resistance wire will be too high or local overheating will affect the service life.

　　4. Keep the resistance wire clean and dry: during the cutting process, some melt will be attached to the resistance wire, which will seriously affect the cutting accuracy and local heating of the resistance wire. Check carefully before and after each cutting.

　　5. Keep constant speed in the cutting process: in the cutting process, the falling speed is too slow, so that the temperature generated by the resistance wire is not easy to be emitted. In order to increase its own temperature, it will seriously affect its service life. The falling speed is too fast, so that the temperature generated by the resistance wire can not melt the template and is in a tight state, which is easy to lead to the bending deformation of the resistance wire and uneven local heating.