Special angle cutting operation of foam cutting machine

　　Special angle cutting operation for foam cutting machine:

　　1. Inspection: check whether the switch of the cutting machine works well, there is no foreign matter around the cutting machine, and the resistance wire is intact;

　　2. Placing objects: place the cutting objects flat on the workbench, and adjust the cutting template so that one side of the template is aligned with the angle on the coordinate paper (the required angle), and the other side passes through the center line of the resistance wire.

　　3. Power on, plug in the power socket, hold the handle with your right hand, turn on the switch with your left hand, adjust the cutting width, and hold the handle with your right hand to drop slowly and evenly (too fast and too slow will affect the service life of the resistance wire and the accuracy of the cutting template).

　　4. After cleaning and cutting, turn off the cutting switch, disconnect the power supply and clean the cutting debris.